BionX Throttle Calibration Instructions NYCeWheels.com

  Do you have a question? Call on 800 / 692.3943


BionX Throttle Calibration Instructions

The directions are slightly different depending on which type of BionX console you have. If you're not sure, check the BionX console page for details.

  • G1 Console throttle calibration:
    1. Press the "Mode" and "-" buttons at the same time until a countdown starts.
    2. Press the throttle lever all the way in and release it. It should show "000" afterwards.
    3. Allow the countdown to complete and turn off your BionX. Done!
  • G2 Console throttle calibration:
    1. Ensure the wire running from the back of the throttle is connected to the console.
    2. Turn on your BionX and watch it count to zero.
    3. Press the "ON" and "-" buttons at the same time until a countdown starts.
    4. Press the red button on the throttle all the way down and release it. The bar graph that filled up when you press the throttle should go to zero afterwards.
    5. As the countdown timer keeps counting down keep pressing fully and releasing fully the red throttle button a few times.
    6. As the timer completes keep the red throttle button completely pushed in.
    7. Allow the countdown to complete and turn off your BionX. Done!
If you prefer a visual guide, have a look at the BionX throttle calibration sheet

If your throttle still doesn't work, contact your dealer for further assistance. If you purchased your kit from NYCeWheels please contact us right away.